Not working to cooldown bed when parameters are met #5

New issue

Open

opened 2021-11-17 02:43:29 +00:00 by Ghost · 1 comment

Ghost commented

2021-11-17 02:43:29 +00:00

(Migrated from codeberg.org)

env.plugins.pi_support.model: Raspberry Pi 4 Model B Rev 1.2
env.plugins.pi_support.octopi_version: 0.18.0
env.python.pip: 21.3.1
env.python.version: 3.7.3
env.python.virtualenv: true
octoprint.safe_mode: false
octoprint.version: 1.7.2

I have printed a few prints, since installing this addon, and it appears it's not working, not certain what's causing the issue. I leverage Arc-welder and MeatPack, I have some custom GCODE scripts at the start and end of a build, but even when there is less than 5 minutes (300s) and the print is over 90% completed, nothing happens on the bed temp target... documentation doesn't have much to assist in what I might be missing. Printer is running Marlin 2+. any troubleshooting steps I can try? I slice in Cura 4.10.x env.plugins.pi_support.model: Raspberry Pi 4 Model B Rev 1.2 env.plugins.pi_support.octopi_version: 0.18.0 env.python.pip: 21.3.1 env.python.version: 3.7.3 env.python.virtualenv: true octoprint.safe_mode: false octoprint.version: 1.7.2

Ghost commented

2024-06-10 15:37:19 +00:00

(Migrated from codeberg.org)

I also seem to be having this issue. Installed a while ago, and haven't noticed it working once.
Have tried installing the print time genuis plugin as suggested, but that doesn't seem to have helped.
Can upload any logs required to help with this.

I also seem to be having this issue. Installed a while ago, and haven't noticed it working once. Have tried installing the print time genuis plugin as suggested, but that doesn't seem to have helped. Can upload any logs required to help with this.